Then somewhere along the line, I became aware that the Champion D16 was the correct cross reference for the Knuckle. So, after all those years I was faced with no longer being able to remember which number was right and which was the one I had used for so many years. Have I mentioned lately that its no picnic getting old?
So for the last couple of years, every time I have been asked for a spark plug for a Knuckle, I have not been able to remember which was correct; D14 or D16. That all changed the other day when I was researching something else. I happened to run across this in Palmer's "How to Restore Your Harley Davidson":
- "Of the original Harley-Davidson 18mm spark plugs, the No. 3 is most often used. For a motor used mostly on the highways at fast speeds the No. 4 plug is more desirable."
And a few lines later:
- "A cheap alternative to the No. 3 and No. 4 18mm plugs are Champion D-14 and D-16 spark plugs, respectively."
Kind of reminds me of the old line "I used to think had made a mistake once, but I found out I was wrong." So, as it turns out either the D14 or D16 is an acceptable plug in Knuck, depending on the use.
I do think I have uncovered a small mistake in the Palmer book though. All the catalogs I have show the D16 as the replacement for the No. 3 plug. This is backed up by a Champion spark plug catalog that I have. The D14 is colder than the D16. The confusion no doubt stems from the fact that in Champion's heat range numbering the lower the number the colder the plug, and Harley did it the opposite way. That's a very minor discrepancy given the huge scope of his book. I have trouble not transposing stuff in just one short blog entry! The important thing is that there are interchanges for both the No. 3 and the No. 4 Harley plug.
With that in mind, here is a page from the Knucklehead service manual.
This drawing illustrates spark plug heat ranges pretty well. A spark plug's heat range refers to how well the plug dissipates heat. A colder plug dissipates the heat quicker, and so runs cooler. Therefore, a hotter plug will help keep deposits from fouling a plug if used in an over rich or oil consuming engine. On the other side of the coin, a colder plug will be less prone to overheating and causing pre-ignition in a high compression engine or one that is run hard (Both high compression ratios and prolonged high speed will generate more heat).
Interestingly, the factory manual states that:
- " In some cases best results may be found using a colder plug in one cylinder than the other. In this case it is usually the front cylinder that takes the colder plug as this cylinder is not as likely to foul a plug at low speed."
I've never tried it, but it seems logical enough. So next time you inspect your plugs and find they are not both the came color, it may be worth your while to try a different heat range! Now you know.